1 A DIVISION OF TRIMBLE875-0042-03 RevAUSB Plus+ RFID Reader Setup Guide
Reading TagsA DIVISION OF TRIMBLE10 USB Plus+ RFID Reader Setup Guide
USB Plus+ RFID Reader Specifications 11 A DIVISION OF TRIMBLEUSB Plus+ RFID Reader SpecificationsPowerDC Power RequiredDC Voltage: 5 VDC (Powered by
A DIVISION OF TRIMBLE12 USB Plus+ RFID Reader SpecificationsRegulatory StandardsFCC 47 CFR Ch. 1 Part 15Industrie Canada RSS-21 0ETSI EN 302 208ETSI E
A DIVISION OF TRIMBLEUSB Plus+ RFID Reader Specifications 13RF InterfaceAntenna ConnectorInternal ceramic antenna with an average gain of 1dBi (Origin
A DIVISION OF TRIMBLE14 USB Plus+ RFID Reader SpecificationsGPIO Sensors and IndicatorsTwo I/O command controlled LEDs Two I/O command queried switche
Compliance Information 15 A DIVISION OF TRIMBLECompliance InformationFCC COMPLIANCEThis equipment complies with Part 15 of the FCC rules for intentio
A DIVISION OF TRIMBLE16 Compliance Information
A DIVISION OF TRIMBLE2Government Limited Rights Notice: All documentation and manuals were developed atprivate expense and no part of it was developed
Contents 3 A DIVISION OF TRIMBLEContentsUSB Plus+ RFID Reader Setup Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Intro
A DIVISION OF TRIMBLE4 ContentsRF Power Output 13Frequencies 13Data/Control Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
USB Plus+ RFID Reader Setup Guide 5 A DIVISION OF TRIMBLEUSB Plus+ RFID Reader Setup GuideIntroductionThe ThingMagic USB Plus+ RFID Reader allows sol
Included ComponentsA DIVISION OF TRIMBLE6 USB Plus+ RFID Reader Setup GuideIncluded ComponentsWith the USB RFID Reader, you will receive the following
Setting up the USB RFID ReaderA DIVISION OF TRIMBLEUSB Plus+ RFID Reader Setup Guide 7Setting up the USB RFID ReaderWhen setting up the USB RFID Reade
Reading TagsA DIVISION OF TRIMBLE8 USB Plus+ RFID Reader Setup GuideReading TagsThe following procedure explains how to install and activate the Reade
Reading TagsA DIVISION OF TRIMBLEUSB Plus+ RFID Reader Setup Guide 9LEDs are “High” when on, “Low” when off.Button/LED to GPIO Line MappingNoteIn th
Comments to this Manuals